Tag: dash
Fiberglass gap fix for the Fiero PISA dash
After the fiberglass cured, I pulled off the duct-tape and trimmed the edges. It will require a little more sanding and body-filler to finish, …but I’m quite pleased with how it turned out.
Dash gap fix
I decided to fix the dash gap with fiberglass, rather than rely on upholstery to cover up the misalignment. Duct-tape was used to form the shape, and act as a removable barrier. It turned out quite well.
Adding support to the centre console
I spent the last three hours adding additional support for the fiberglass center console – a.k.a. the armrest. It involved fabricating a metal bracket and a fiberglass ledge. I also mounted the shifter boot – this boot is just used as a mock-up. I have…
Fiero dash – added lower steering column cover
Adding the steering column cover was pretty straight forward. I needed to trim the edges off, and drill two holes at the top to hold it in place. Other than that, the stock mounting locations were used.
Progress on the Fiero dash – AUX gauges
Today I added the auxiliary (AUX) gauges to the dash – voltmeter and oil pressure gauges. I re-used the old plastic housing piece because it gave a mounting fixture for the gauges. It involved a little cutting because the pig-tail wire that plugs into the…
Fiero middle armrest console
Today I finished installing the middle armrest console – it involved a little bit of trimming. Unfortunately it has a rather large gap on the passenger side – i’ll need to get creative to solve that. I also started mounting the switches. I did not…
Fiero dash mounting brackets are done
Today I finished mounting the dash to the chassis – driver and passenger sides. With the driver’s side, I re-used the old Fiero dash bracket to mount the hood release. On the passenger side I also re-used the old Fiero bracket – I created rubber…
Fiero PISA dash – installation of the instrument cluster
In order to successfully mount the main Fiero instrument cluster, I needed to drop the steering column. Once it was disconnected, I could properly mount the gauges. Note that the original location for the “hidden” cluster mount actually maintains alignment – but it’s “underneath” the…
Fiero dash is partially installed
The PISA dash is partially installed. I have drilled and mounted the upper points – near the speakers. The HVAC ducting is not in place yet. Once I get the dash roughed in, I will pull it out and install the ducts. Sorry for the…
Fiero dash speakers and HVAC vents
I had some time today to cut out the holes for the dash speakers and the HVAC vents. I used a cardboard template to help transfer the hole locations.
A little progress on the Fiero dash
I had some spare time today to cut out the radio console.
Fiero dash continues
I made a few more cuts, and now it can fit inside the Fiero. I’ll need to do some trimming but the overall fitment isn’t too bad.
More progress
A few goodies arrived for the Fiero: – A set of 16″ Z24 Cavalier rims with 90% tread left – picked these up for $100!; – Amber LED marker lights that are flush mounted; and – LED switches with chrome aircraft guards. I also made…
