Tag: bracket
Man cave build-up
Man cave build-up. AKA, the garage. I will let the pictures do the talking…
Honda Civic EVAP purge valve fix
When replacing the EVAP purge valve (valve that re-circulates the gases in the gas tank) the embedded nuts in the canister rust-weld and fall right out – especially for those in a northern climate. To fix this, remove the embedded nuts entirely and go to…
Fiero interior pieces are back from upholstery
The interior pieces came back from upholstery, and all I can say is WOW. I can’t wait to get these installed! The pictures don’t do them justice.
Fiero alarm siren and custom LED switches
Today I finished mounting the alarm system siren. I used an aluminum bracket to attach it to the chassis. I also mounted three custom LED switches (purchased last year) to the interior power window plate. I will run the fog lights to one of the…
Installation of the Fiero electrical junction box
I have completed the installation of the custom junction box to the Fiero chassis. This will allow easy electrical hookup for the aftermarket accessories.
Installing truck bull-bars on the Colorado
This entire process took about 4 hours – 1 hour to install the bull-bars and 3 hours to mount and wire in the fog lights. Due to the laws in Ontario (Canada) a front license plate must be mounted. These bull-bars interfere with the stock…
Fiero PISA dash glove box install
It took a while for me to think about how I was going to mount the glove box door. I found a set of 1″ brass hinges (at Canadian Tire) that were small enough to be hidden, …but big enough to provide support strength. The…
Fabrication of custom bracket for Fiero junction box
Since I am installing the PISA Fiero dash, I have some room to add an electrical junction box. This junction box will act as a future expansion for interior electronics. I used an existing bracket I pulled from the Fiero and welded it onto another…
Adding support to the centre console
I spent the last three hours adding additional support for the fiberglass center console – a.k.a. the armrest. It involved fabricating a metal bracket and a fiberglass ledge. I also mounted the shifter boot – this boot is just used as a mock-up. I have…
